Akai MPC5000 Specifikace stáhnout pdf (Strana 106)

MIXER Mode 92

will be played with changing the Level or the Pan as you did during the recording when 'Play Track Mute Events' is set to ON. The mixing data

recorded in the sequence is displayed in STEP EDIT page and you can edit it same as other MIDI event.

Note: Level event shares with Level of Q-LINK.

 Shortcut between MIXER and EFFECTS mode.

While in MIXER mode, you can easily switch to EFFECTS mode by pressing [F6] (GO2FX).

While in EFFECTS mode, you can easily switch to MIXER mode by pressing [F5] (GO2MIX).

Tip: This is especially useful when searching for the right effect for the right sample.

Take Over Mode

When 'Take Over Mode' is active, when on the TrkMIX, PrgMIX, HD MIX,

SYNTH, and EFFECTS EDIT pages, moving a Q-LINK will only update

when the current value of the control is crossed.

For example, if a HD MIX Channel is set to a volume of 70, and the

corresponding Q-LINK is set to its minimum position, if 'Take Over Mode'

is active, the channel's volume wouldn’t change until the Q-LINK moves

past 70, allowing for a smooth volume adjustment. If 'Take Over Mode' is

off, the control will change to follow the Q-LINK immediately.

To activate 'Take Over Mode', do the following:

01. In MIXER Mode, press [F3] (SETUP)

This will open the SETUP Tab.

02. Select the 'Knob / Slider Take Over Mode' field and select 'YES'

Take Over Mode will now be enabled.

Tip: 'Take Over Mode' applies to the TrkMIX, PrgMIX, HD MIX, SYNTH pages, and EFFECTS EDIT page. Q-LINKs set in

Q-LINK mode always work as immediate access, regardless of Take Over Mode setting.

Input Thru

The MPC5000 can mix the incoming signal from RECORD IN or S/PDIF IN

with the play back sound from the MPC5000.

You can also route the Input Thru signal to one of the four effects busses,

and you can control the level, pan, effects send, etc of incoming signal

with the Q-LINK sliders and knobs.

 Applying effects to an incoming signal

Note: In this explanation, some Effect should be selected first. If you don’t have any, select some Effects as described

in the chapter entitled 'Effects' on page 149.

01. Press the [INPUT THRU] button.

The INPUT page will be displayed.

You can also get to the INPUT page by pressing the [F4] (INPUT) button in MIXER mode.

02. In the 'Input thru' field, select ON.

03. Set the 'Src' field to ANALOG

You can also set DIGITAL here to be able to listen to digital S/PDIF sources.

04. Set the Mode field to STEREO, MONO-LEFT or MONO-RIGHT.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 221 222

Žádné komentáře

Akai MPC5000 Specifikace Strana 106